reede, 30. jaanuar 2015

ALOT Step 1

To make the construction of ALOT easier and quicker, the hull sides are made of 1"x 12"x 12 white pine boards.  This eliminates the need for adding fastening strips if thinner plywood is used for the sides.  It also eliminates the needs for sheer rails for stiffness.

Take some time to pick nice pine boards.  Look for boards with as few knots as possible, boards that are straight and do not have excessive cupping.

The white pine boards were aligned using clamps, then the 15 degree angled transom was cut using a jigsaw.



Tools needed: Sawhorse, measuring tape, clamps, jigsaw, pencil.

Related Posts:

  • Design 2263 17 DaysailerThese plans were part of a design proposal at the request of the Boston Whaler Company for their first foray into the sailboat market. The year was 1975.The basic specifications were to be:1. Performance - it should be a goo… Read More
  • Diy Swim Platform180se DIY swimdeck posted in gravy holder Talk Aloha State everyone Im nerve-racking to bond angstrom I reckon youre going to be forced to raise your swim platform. Admit it Has anyone successfully built their have swim polit… Read More
  • Cardboard boat racers take to waterAMATEUR boat-builders took to the water, paddled, and sank in a variety of vessels — made out of cardboard: For the full story.   Over at Sailboat Plans I show you how I made my own plywood boat, cheap and fun to do.… Read More
  • Design 297 Privateer ClassThis early example of a "stock" design was developed in 1939 at the urging of Drake Sparkman. I am not exactly sure of how many of these boats were built. We have confirmation of three boats for sure: Rattlesnake built by … Read More
  • Floors Glue Up shaping sheer clampOne small sentence in the instructions couldnt take three days...could it?!!  But yep, gluing in the floors is quite time consuming so by the time I had refined their fitting and drilled for the screw… Read More

0 kommentaari:

Postita kommentaar